Hi Guys,
I'm swapping out my 72 motor for an 82. In order to swap over my Pamco I'll need to install bushings on each side for the advance rod.
I read here that I can use three metal bushings instead of the labyrinth seals -- and that I should be able to install them by hand.
The bushings that I received from Mikes seem like they'd need to be pressed into the cam. Are there any tricks to installing these? I was thinking of using a threaded rod and a big washer to push them in but I wanted to check with the experts first!
Thanks, everyone.
I'm swapping out my 72 motor for an 82. In order to swap over my Pamco I'll need to install bushings on each side for the advance rod.
I read here that I can use three metal bushings instead of the labyrinth seals -- and that I should be able to install them by hand.
The bushings that I received from Mikes seem like they'd need to be pressed into the cam. Are there any tricks to installing these? I was thinking of using a threaded rod and a big washer to push them in but I wanted to check with the experts first!
Thanks, everyone.
Last edited: