The jack project has been jacking me around. The end cap had been ground down so far by getting dragged on the floor that I couldn't get it to seal, oil everywhere. Typical 4 projects back, got the TIG in the garage, cord end changed to match shop 220, wiring fault (mine) fixed, gas leak repaired.
Built up and turned down the end cap.
Also welded some pivot pins that I had to grind out to remove, even 50 years ago not everything was designed for service. So back together waiting for silicone to set will fill tomorrow and hopefully get a bike back on the lift.
Santa hinted I'm getting a grinder.....
Built up and turned down the end cap.
Also welded some pivot pins that I had to grind out to remove, even 50 years ago not everything was designed for service. So back together waiting for silicone to set will fill tomorrow and hopefully get a bike back on the lift.
Santa hinted I'm getting a grinder.....