fnickel
XS650 New Member
Got a problem with BS38 diaphragms. I installed a set from JBM about a year ago. Within a week, the slides started rotating within the diaphragm, making it run bad. I used the best silicon adhesive (fuel resistant) that I had to glue the surfaces between the slide and diaphragm. It last about a year, and the same thing has started to happen again. Any recommendations for a permanent bond between the slides and diaphragms?
Also, I now have a tiny pinhole in one of the diaphragms near the outer edge. Is there any material or goop that I can use to patch this pinhole, or am I stuck ordering another diaphragm? Thanks for your help.
Also, I now have a tiny pinhole in one of the diaphragms near the outer edge. Is there any material or goop that I can use to patch this pinhole, or am I stuck ordering another diaphragm? Thanks for your help.