angus67
Welder's penetrate deeper!!
so, any ways, ive been working on a friends 71, and got it all sorted, and eventually starts with alot of kicking. It will warm up fine, then when I take off the choke, it will idle for a few minutes I can revit up, but it quickly floods out. It wont restart, and the plugs are soaked. the mix screws are 3/4 out, needles 3rd notch, Battery at full charge, strong coils.
when I had the carbs apart, (bs38's) I noticed the small o-ring around the emulsion tube is deteriated. could fuel be finding itway around the jet/needle flooding it out? I ordered new rings from mikes. I hope its that simple. Ive got the poionts dead on, timming right. when it starts, it sounds great, welll ballanced rite/left.
if that isnt it, then what? drop the needle a notch?
floats are not sinking.
when I had the carbs apart, (bs38's) I noticed the small o-ring around the emulsion tube is deteriated. could fuel be finding itway around the jet/needle flooding it out? I ordered new rings from mikes. I hope its that simple. Ive got the poionts dead on, timming right. when it starts, it sounds great, welll ballanced rite/left.
if that isnt it, then what? drop the needle a notch?
floats are not sinking.