Luckydog
XS650 Enthusiast
Heres the scoop. 500 or so miles on a new bobber build with just the basics for wiring.
Hughs PMA, Pamco, E advancer, all new wiring done meticulously. Have about 500 flawless miles on it. Today it sputtered for a few seconds and then died completely. I did manage to re-start it but only to a short sputter and then nothing.
After checking just about everything here is what I have.
New barttery 12.12v
I have 11.7v at the coil (mikes Part #17-6903)
Primary to primary 2.6 Ohms
Primary to center - infinate
Primary to plug terminal - infinate
Plug terminal to center - infinate.
Plug terminal to plug terminal 17000 Ohms
Turned the bike over by starter button - no spark
Removed pin on Pamco turned by hand - no spark
Bad Pamco???:
Any help would be much appreciated.
Hughs PMA, Pamco, E advancer, all new wiring done meticulously. Have about 500 flawless miles on it. Today it sputtered for a few seconds and then died completely. I did manage to re-start it but only to a short sputter and then nothing.
After checking just about everything here is what I have.
New barttery 12.12v
I have 11.7v at the coil (mikes Part #17-6903)
Primary to primary 2.6 Ohms
Primary to center - infinate
Primary to plug terminal - infinate
Plug terminal to center - infinate.
Plug terminal to plug terminal 17000 Ohms
Turned the bike over by starter button - no spark
Removed pin on Pamco turned by hand - no spark
Bad Pamco???:
Any help would be much appreciated.