Ok. So I have my chopper just about done. The last step yesterday was to install the pamco and Pma. Ordered from mikes xs I got the xs charge pamco with pma. I installed, wired and kicked over. Fired right up. Ran great. For 30 seconds and died. Kicked again and started. Ran for about 5 seconds and that's all she wrote.couldn't get it to start again. I know it's timed right because I followed all instructions on the HHB site. I know I have good fuel, great compression, and damn good spark. So I'm thinking my issue is carbs too lean. But the air fuel screws are stripped in the carbs I have, so I pulled them and tomorrow will order rebuild kits. Just want to see what everyone else thinks. I know this has been asked a million times and I have searched every last thread. Do you guys think my issue is carb related? Thanks in advance.
Purcell
Purcell