Shipper
XS650 Addict
In the past I have replaced push rod bushings and seals with no problems. This time around I am doing a full rebuild with gear shafts removed. Upon inspecting the push rod channel, it appears that the bushing has been removed on this shaft but it also appears that the whole bushing may not have been extracted. I have searched the sites in the garage forum but can't find a picture of a shaft with the bushing removed. Should that shaft bee absolutely smooth from end to end or is there a lip as appears to be the case in the pic below.
If thats a bushing residue piece, how can I get it removed without damaging the shaft.
Thanks mates.
If thats a bushing residue piece, how can I get it removed without damaging the shaft.
Thanks mates.