Ok, so finally got the bike out on the road after the two year project (pic attached). One of the problems I am having is moving up/down through the gears. I had a hard time getting the bike to shift into 3-5, usually had to rev the engine slightly, it would find gear and then go in. Looking at some forums and searches this weekend I see the common cant find neutral issue (yes I am plagued by that). I am thinking the clutch adjustment is set incorrectly and I need to redo that? Would this take care of both problems?
The bike is a '78 Special which I replaced the clutch plates and needle bearing. Per some of the recommendations, I am running 20-50 Pennzoil no additives.
The bike is a '78 Special which I replaced the clutch plates and needle bearing. Per some of the recommendations, I am running 20-50 Pennzoil no additives.