Hey... Figuring out my rear axle spacing on my chop and need some help...
When I dismantled my 79' I obviously didn't pay enough attention, I have all the bearings and seals in, and have the appropriate dust shield on each side... But then what.... Is it just the caliper between the brake side, is there a collar/spacer on the drive side?
I tried looking at the schematic online but its horrible to look at...
Even better, could someone take a picture from the rear to show the spacer set-up
Or if someone could measure the width off the swingarn between axle plates, and measure the distance on each side, from dust seal to axle plate...
Thanks!
When I dismantled my 79' I obviously didn't pay enough attention, I have all the bearings and seals in, and have the appropriate dust shield on each side... But then what.... Is it just the caliper between the brake side, is there a collar/spacer on the drive side?
I tried looking at the schematic online but its horrible to look at...
Even better, could someone take a picture from the rear to show the spacer set-up
Or if someone could measure the width off the swingarn between axle plates, and measure the distance on each side, from dust seal to axle plate...
Thanks!