I have a bad oil leak that seems to be coming from between sleeve #1 in the diagram below and the case. #1 also seems loose. It seems to me I need to replace o-ring #2. Or is there something I'm overlooking?
My big question - if I remove screw #5, to get sleeve #1 out, will #7 or #8 fall into the case? I read warnings about this but they aren't clear about what causes that to happen.
Thanks.
Also - anybody know the size for the o-ring?
~~~~~~~~~~~~~~~~~
Also, after a bit more research, how difficult is it to remove sleeve #1 while leaving the gear undisturbed, say pushing down on the gear shaft with a screwdriver? Has anyone done this?
My big question - if I remove screw #5, to get sleeve #1 out, will #7 or #8 fall into the case? I read warnings about this but they aren't clear about what causes that to happen.
Thanks.
Also - anybody know the size for the o-ring?
~~~~~~~~~~~~~~~~~
Also, after a bit more research, how difficult is it to remove sleeve #1 while leaving the gear undisturbed, say pushing down on the gear shaft with a screwdriver? Has anyone done this?
Attachments
Last edited: