Recent content by bikesbybruce

Here is a Youtube vid of the build that doesn't suffer from the depth of field in the still photos.

Thanks :)

LOL. Soon as I find someone that makes one in photoetch it's going in.

Here's one for fun. Another diversion to pass the time before the snow melts and another riding season starts. It's a 1/10 Minicraft that was already started by someone else and I picked it up on EBay. All mistakes, omissions, errors and not getting it completely right are 100% my own. If it...

Please forgive me if this subject has already been covered. My 81 had a fried TCI so I went to points taken from a basket case. Saw the horror stories about cracked cam towers, oversize bushings, etc. I gently honed out the cam bores for the advance rod bushings on both sides with a Dremel and...

These are brighter and make it much easier to swing a leg over the back.

Bonus: They are very lightweight compared to the stockers.

I turned down the stalks on the front ones so they'd be right in close by the headlight tabs by chucking them in a drill and using a hacksaw as a chisel. Barnyard Engineering. It worked.

The stock lollipops had to go after 40 years.

This misfire on one cylinder really had me puzzled on my '78 Standard. I noticed when I was looking at areas for possible vacuum leaks that the copper (brass?) tubes used for the vacuum fuel shutoff valves, that are pressed into the inlet spigots, can work loose over time. I found the problem...