Latest activity

Stayed up and figured it out. The lower is ok👍😀. What was sticking was the cone shaped fitting on the end of the damper rod, fitting...

That looks like a Laverda Triple with the red side hack. With straight pipes !

Yes, the P.O. could have very well clamped it at the bottom and that part is now oval inside. If the tube never gets that far in with...

Well that would be bad news, but could explain what’s happening. When working on the forks, I never clamped the lower like that, but...

When you had the FJR you did not get to adjust any shims?

Well, that happens when the lower was clamped in a vice and is now oval inside instead of round, lol. We had to replace one of the...

I have 750 kit, megacycle cam, some porting done, looking for VM 34 set up suggestions, cant seem to dial it in?

Can you tell me your VM 34 carb set up, jetting and so on, thanks CM

Didn’t get back in the garage tonight…first day back out on the TN River in the Jon boat :)

I’ll check when I get them back apart. Doing a frame off with a buddy on a basket case 74 right now as well and will check that set also.

Well I got my seals today. They went into the lower tubes with old moderate bashing. They were most likely looser fitting than before...

Holy $@#+ that was a pain. I though everything was wrong. Turned out pulling the caliper off worked. Holy crap that was annoying. Thanks...

So as it would turn out nothing is out of round. The guides are the same all a round as well as both intake and exhaust port and valves...

Yes, it can be hard sometimes to re-fill a completely empty system and get it to build pressure. I start out using a Mityvac vacuum pump...