Recent content by m1ster2

Thank you for all the good information! I put everything back together, in the right order with out the extra washers in it, New clutch disks, springs, etc... it seems to have made the right difference. In the future I might try and find one of the newer baskets to put in, but for now this is...

Problems run deep. So I pulled it apart, and besides the fiber plates being super worn down, the inner basket was installed with a 30mm nut spring washer and a washer. The inner basket is all chewed up and honestly doesn’t even look like it’s from a 650 as it doesn’t have the spot for the...

Update, replaced the missing bearing, unfroze the clutch, readjusted everything, it still drags....but now the issue is if I’m at a stop I can’t shift it back into neutral...so I’m gunna tear everything apart and see if all the washers and bearings are in place, and while I’m at it, replace some...

Thanks for the replys! And for pointing me in some good directions. Yes the motor runs, tho I am not certain how long it sat before I got it going again. I tried letting everything warm up to see if that made a difference. I had it up on a stand and tried to see if I could unstick the clutch...

Thanks, I'll check it out in the morning!

Hey everyone! I know I’m a total noob to this forum in posting but I’ve been constantly searching through and found a lot of good help and advice here! But here come my issue... So I have a 79 that I picked up as a project a little while ago and have been getting it back to running order. So...