Recent content by mandm

Great shop and work is amazing.

.........................................

FS: 21" front spoolie rim. 150.00 OBO Somebody did a crap job of painting it white. I rubbed on it a little and it came right off, that's why I'll let it go cheap. Has a ribbed Dunlop mh-90-21 that doesn't look that bad. I have a new set of bearings ("3/4 I.D.") for it.

I just listed a '73 front end, but brake mounts have been smoothed.

I have a '73 front end for sale or trade - No reasonable offer turned down.

Hello, This may help. (David Bird) https://davidbirdhardtails-com.3dcartstores.com/assets/images/pdf/stretch%20and%20drop.pdf

Decided to part it out some of this bike. It's no longer for sale. Thanks

I answered too quickly - I should have read - I need something different and can't use them. Thanks though.

I'll take them -

I cut mine in half...

I have a set of 82special hubs, new ss spokes and new rims (16 rear/21 front), and new tires for both. PM if interested. They need to be assembled.

Pamcopete - I bought this bike with the PMA rotor installed and no marks. By "30 degress beyond" i mean that spark occurs at the point where I've drawn the arrow - which I'm assuming as 30 degrees advanced from what it should be. I'm also assuming that there are 3 marks that should be made for...

Thanks for your input. I plan to take some better photos later. I've checked timing on both spark plug leads with same results. I've attached a photo of what I'm calling 30 dig beyond BTDC. It fires on the arrow at slow idle and advances beyond that arrow when revved up.

Looking at timing right now -- hope to get this 100 percent to be a good daily rider for someone.

Hello, I've searched this forum and the internet and have not found my answer yet. My bike is running Pamco, E-Advancer, PMA, Normal Battery. It's a '73. I've been slowly tuning it up to sell it. When I got it, it had a standard ignition/points. Before doing anything, I followed the...