Recent content by pipo_pk

Thanks again, Thankfully I have a friend working a fabrication shop so he's been kinda enough to supply me with some thick plate steel and 'I' beam that should be up to the job, will allow me to safely push the press up to 12 ton :O)

Thanks for this advice. My press is 12 ton, I’ve applied about 4 ton but need to get the centre crank to move another 2mm 🤔 Perhaps it just need some extra tonnage to move just a little more!

Wondering if anyone could shed some light on an issue I have reassembling my XS crankshaft. The spec seems to say that the width of each camshaft should be 66mm +\- 0.05mm - 0.1mm. The overall measurement between both crank should be 186 +\- 0 - 0.3mm. This is where my problem lies. The...