Search results

Hey guys I have an 81 tci that possibly took a dump. Replaced coil everything checks out though pickup, battery fully charged etc. Anyhow was looking at pamco ignitions and wasn't sure if for some reason they need the PMA swap also to work? Stock charging system still works flawlessly so really...

hey all. i have had the tender on my 81 for a few days now. after about 12 hours the red light was on also with the green light flashing indicating 80% or more charged. but two days later and the green is still flashing. all lighting circuits are ran after a switched key so they dont work unless...

Hi guys rejetting the 81 for open pipes and pods. Was on mikes xs looking at needles and seen that the needles also have a corresponding needle jet. Can I just get the needles and use the stock needle jets? Carb is stock jetting. Thanks. I've only jetted 2 and 4 stroke MX bikes so the needle...

Hi guys starting to run lighting circuits on my 81 build. This is the wiring that I used, it shows the fuse after brake switch for the tail light but can I put the fuse before the brake switch and still be protected. It would just save me some headache. I'm using an auto fuse block instead of...

Hey guys new to the forum. Starting rewire in a couple days. 81 tci engine. Rewireing from sccratch, my question is all bobber harness diagrams I read have a main generic keyed switch but then there is a seperate kill switch prior to the coil. Is this necessary or strictly for safety. I...