Search results

Holy Hardware Batman!...Count me in!

Looking for yet another winter project: new front brake would do the trick!:thumbsup:

I'd love a set: count me in!

Those are sweet: please count me in!...Thanks!

Would be verry nice to have those!... :bike:

"Bench syncing"?...[forgive my ignorance], but what's the best way to do that?:confused:

I have more than enough cable length to work with [didn't have any problems routing it], so I don't think that not enough free play is a problem. Could having too much free play be the issue? What's frustrating is that I just want to let the engine warm up to normal temp so that I can...

OK... so I mounted the carbs, hooked up gas lines, put in fresh plugs, etc., and connected the throttle cable. I turned the air screws in until they seated and then turned them out 1-1/2 turns and upon starting her up she was running rough. This I expected, but while waiting for her to warm...

OK... so I mounted the carbs, turned the air screws in until they seated and then turned them out 1-1/2 turns and upon starting her up she would run rough. This was to be expected, but while waiting for her to warn up, if she started to drop in RPMs to the point where I thought she would...

Roger Wilco! :thumbsup:

Great info! OK, unfortunately at this point I don't know if I'm going to be able to even get a set of vacuum gauges in time for the installation tomorrow morning [much less a "mercury stick"]. But I am determined to get these on the bike & ride the 20 miles home - since I haven't ridden...

OK, looks like I'm off to Harbor Freight for some vacuum gauges...and I'll try to find a brass T with 1/4" barbs for the fuel system set up. Last question: where did you end up getting [and what] the cable/parts to take care of the cable issues? Thanks again for all your advise!

Thanks mrriggs! I appreciate you sharing your insight [no doubt obtained through hours of hard work!]. However, I will not have access to a mercury manometer at the time of the initial installation at my friends house tomorrow - do you have any suggestions on how I can get "into the...

Hi All: For better or for worse, I've ordered a set of these from MikeXS. The BS 34s on my '80 SG are shot and I haven't been able to ride yet this year so I figured I'd give these a try. They arrive tomorrow, so I'm going to install them Saturday. Having said that, short of printing out...

Hi All: For better or for worse, I've ordered a set of these from MikeXS. The BS 34s on my '80 SG are shot and I haven't been able to ride yet this year so I figured I'd give these a try. Having said that, short of printing out the many pages of discussions [on many threads] on this forum...