Search results

  1. M

    Adjust position of the camshaft?

    Hello two years ago I changed the cylinder head (XS650 1980) and probably didn´t place the camshaft 100% precisely. There´s always a bit oil coming out of the ignition housing and the centrifugal advance housing. I changed already the rubber seals and seal rings. Question: Is it possible to...
    • marrow
    • Thread
    • camshaft moving oil leaking camshaft
    • Replies: 33
    • Forum: The Garage
  2. M

    Ignition points don´t open/close anymore

    Hello I had to change the gaskets at the camshaft, ignition point side. When everything was back in place, when I wanted to adjust the ignition, the points didn´t open or close anymore, not moving, as if the ignition point cam had lost its hump. I took everything out again, checked it, back in...
    • marrow
    • Thread
    • ignition point ignition point cam
    • Replies: 8
    • Forum: The Garage
  3. M

    Changed governor - failing

    Hello I have the following problem: I had to change the governor. The old one broke due to a not 100% tight screw, so it came off, spinned and collided with the little pin. So I installed another governor (used). Then it was impossible to adjust the ignition, the test lamp always came on before...
Back
Top