Search results

hello all thought i would share this with you..i was suffering with charging problem on my 81 it was the rotor 0.5 ohms so i got a after market one off ebay .it started and charged fine but after 30 mins it wouldnt rev up got it home in the morning started and ran fine for 10 mins then...

hello again rebuilding my 81 engine ive got a new rear camchain tensioner slipper. the old one i took out had a hollow for the tensioner plunger to fit in the new one hasent is the old one worn from beeing over tightned ? or should the new one have a divit in it for the plunger to fit...

hello again im just cleaning my crankcases ready to rebuild engine and noticed a small round gasket that sits between the two halfs its about 10mm round and it blanks the gearbox oil pressure feed close to push rod oil seal does this come with the complet gasket set or not?if not what do you...

can anybody tell me .if any of the bearings on my 81 has plastic / nylon parts in them holding the balls apart or are they metal...crank.gearbox clutch etc as ive got large white plastic in oil many thanks...

hello everybody..ive just changed oil and filters and found four large bits of white plastic/bakerlight very hard stuff in the small right hand filter housing..dont know what it is or where it came from.i replaced both filters when i changed oil 1000 miles ago sump filter is perfect any idea...

hello can anybody tell me if a 78 7 plate clutch complet will fit straight on to my 81 im suffering with very bad clutch slip when warm.or is a 6 plate clutch good with new plates and springs many thanks