BarrieC
XS650 Addict
Hey Guys,
just running through my parts to see what i need down the road to get this Basket case back to life.
Ignition and charging plays on my mind, here is what i have:
Just been checking out my Stator - I have 3, one with the Pick-up 2 without. and the Stator case is horribly corroded, you can even see the TDC mark (photo below)
The other 2 stators are in good condition screws etc.
I was thinking, i would have to remove the windings from my original one and fit them into my case of choice, but i think i can just mount the Pick-up in the "new" case and change the brush mountings as required?
Have a look at the photo below - as you can see the top left is the offending item,
I'm hoping its just a case of drilling and tapping out the mounting holes for the Pick-up
Thanks guys
Barrie
just running through my parts to see what i need down the road to get this Basket case back to life.
Ignition and charging plays on my mind, here is what i have:
- A bike that was originally Electronic (its not CDI, i know) ignition.
- Transistor box, Correct Coil, Correct Regulator/Rectifier
Just been checking out my Stator - I have 3, one with the Pick-up 2 without. and the Stator case is horribly corroded, you can even see the TDC mark (photo below)
The other 2 stators are in good condition screws etc.
I was thinking, i would have to remove the windings from my original one and fit them into my case of choice, but i think i can just mount the Pick-up in the "new" case and change the brush mountings as required?
Have a look at the photo below - as you can see the top left is the offending item,
I'm hoping its just a case of drilling and tapping out the mounting holes for the Pick-up
Thanks guys
Barrie