IMG 17- Close up of old bushing removed. Drill bit recommendations from Mike XS were spot on!
IMG 13- Chamfer-a symmetrical sloping surface at an edge or corner. Or just grind the edge lightly and evenly to allow ease of rubber gasket installat
IMG 14- Light cleaning afterwards with a Dremel stainless steel brush.
IMG 15- New bushing on the left, 11/32 drill bit used first, to start the opening, followed up by a 23/64 drill bit used second and the old bushing sh
IMG 17- Close up of old bushing removed. Drill bit recommendations from Mike XS were spot on!
IMG 18- I used a magnetic screwdriver to swipe the leftover shavings, to make sure no metallic pieces were left over.
IMG 19 Start bushing in a clean application, before trying to set it flush.
IMG 19A Old bushing came out on 23/64 bit, this was the second of two drill bits to be used, the first bit should be a 11/32.
YAM277

IMG 17- Close up of old bushing removed. Drill bit recommendations from Mike XS were spot on!

There are no comments to display.

Media information

Album
Clutch Pushrod Shaft Bushing Replacement Pics
Added by
YAM277
Date added
View count
623
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top