IMG 18- I used a magnetic screwdriver to swipe the leftover shavings, to make sure no metallic pieces were left over.
IMG 14- Light cleaning afterwards with a Dremel stainless steel brush.
IMG 15- New bushing on the left, 11/32 drill bit used first, to start the opening, followed up by a 23/64 drill bit used second and the old bushing sh
IMG 17- Close up of old bushing removed. Drill bit recommendations from Mike XS were spot on!
IMG 18- I used a magnetic screwdriver to swipe the leftover shavings, to make sure no metallic pieces were left over.
IMG 19 Start bushing in a clean application, before trying to set it flush.
IMG 19A Old bushing came out on 23/64 bit, this was the second of two drill bits to be used, the first bit should be a 11/32.
IMG 20 Tap in bushing with flat solid item.
YAM277

IMG 18- I used a magnetic screwdriver to swipe the leftover shavings, to make sure no metallic pieces were left over.

There are no comments to display.

Media information

Album
Clutch Pushrod Shaft Bushing Replacement Pics
Added by
YAM277
Date added
View count
664
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top