Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Enjoy XS650.com?Consider making a donation to help support the site. XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Thanks for this, Guys!
I used this wiring diagram.
I haven't had a chance to check the voltage on the bike yet (it's at a garage across town). Should I also move the fuse to a different location than the above?
I did not precharge, I took the Antigravity battery straight out of the box.
Hey Guys,
I switched over from my capacitor over to an Antigravity battery. The bike starts/runs a lot stronger but now it blows fuses as RPMs rise to mid-range. This bike never blew a few before, all I did was change the battery. Voltage regulator is new last season. I redid my wiring last...
Hi Guys,
I'm swapping out my 72 motor for an 82. In order to swap over my Pamco I'll need to install bushings on each side for the advance rod.
I read here that I can use three metal bushings instead of the labyrinth seals -- and that I should be able to install them by hand.
The bushings...
Hi Fellas,
I'm looking to swap motors from a 72 to an 82. I'd like to retain my BS-38s carbs though. Are the carb holder holes on later models the same distance apart? I.E. can I swap over my BS-38 carbs and holders onto a 82 engine?
Are there any other issues with putting an 82 engine into a...
All,
I recently added a second headlight to my bike (traditional two rectangle chopper headlight look). Each headlight runs a single 12v H3 halogen bulb. Grounds are all good -- I can ride with either light but not both. When I put both headlight wires into a single terminal and connected it to...
5Twins,
Thank you for this. I only replaced the steel drive plates and friction plates. I remember when I changed them going through the struggle of getting the stack the right thickness.
I used EBC CK2242 clutch plates and EBC CSK14 clutch springs. I think I used 7 EBC friction plates...
2M,
I tried a hard launch in second gear and it made the grinding sound again. I'll take a look at the clutch later this week.
What did you mean by checking the washers?
All,
XS2
This issue started after replacing my clutch last season. It never happened before then.
When I put the bike into first gear and take-off quickly (high torque) sometimes I get this weird grinding sound from somewhere in the motor. I know that the word "grinding" immediately makes...
(Also running Iridium plugs)
Thanks for the input so far, I really appreciate it.
Assuming one of these components (boot, wire) is bad would you recommend I reorder from Mikes? I know they sell their wires and boots as "high output" and bundle them with the ignition, but I'd love to find them...
Hi Guys,
Looking for some insight on an electrical issue. I'm running PMA/PAMCO with capacitor on a 72 XS.
Bike was running fine, then lost spark on one cylinder and blew the fuse. I haven't touched the carbs (or anything else).
Between blowing the fuse and starting the bike again I...