Recent content by xjeffx

sold super super SUPER fast.... sorry everyone

I just purchased this from mikesXS for $299.00 + shipping but decided to stick to my Mikuni's. They have been set up and installed but not re-jetted or anything. You may need to purchase more fuel line. ($1.00 on mikesXS) The bad: - I am keeping the pod air filters so they are NOT included...

The hole on the hub is lined up right clutch is adjusted right, at the worm gear and lever. I used SAE 30 oil.... does that matter?

The facts for my 1980 xs650: -Have 6 friction plates and 5 clutch plates. -Put oil in and kick started fine -Pulled clutch in with lever, put in first gear and released the clutch all the way slowly and all it did was slightly jolt forward. I could feel the bike wanting to move forward. It...

I have read through this section multiple times. My cables are all set and good. Should i connect my vacuum barbs with a single hose?

figured it out.... smallest short up by the coils... thanks

I figured it out.... had the smallest short up by the ignition cable..... thanks for all your help

I bought these carbs, put them on my bike with straight exhaust, start it up and the thing revs so high and does not stop till i turn the keys off. Thought the engine was going to EXPLODE!!! any ideas? anyone have a diagram? thanks

thanks you both.... i will try this this weekend

there are no other shorts and the rectifier was completely isolated....

I purchased a 6pin CDI wiring harness from TC Bros for my 1980 xs650. I followed the instructions perfectly but it keeps shorting out when i turn the keys. I have narrowed it down to the red and brown wires from the kit that are supposed to connect to the ignition switch from the...

I purchased a 6pin CDI wiring harness from TC Bros for my 1980 xs650. I followed the instructions perfectly but it keeps shorting out when i turn the keys. I have narrowed it down to the red and brown wires from the kit that are supposed to connect to the ignition switch from the...

I purchased a 6pin CDI wiring harness from TC Bros for my 1980 xs650. I followed the instructions perfectly but it keeps shorting out when i turn the keys. I have narrowed it down to the red and brown wires from the kit that are supposed to connect to the ignition switch from the...

i'll try to get some pics up soon. Thanks for your help.

the clutch is assembled. How am i missing a ball bearing? did it fall in the engine?