Pattymatts
XS650 Member
What's up guys. I have a chopped, kickstart only, 81', and I'm pretty sure the ignition is kaput. About a month ago I was about to go for a ride but it wouldn't start. I kicked it for about 45 minutes until my battery finally died and no joy. Buddy came over, tried push starting, still nothing. Was pissed off and in one last valiant effort to kick it, it fired right up. I was in shock so I stood there mouth open and puzzled for about 30 seconds, then I blipped the throttle and, as if someone hit the kill switch, just died. Would not start up after that. Pulled the carbs, they seemed fine, plus they were recently rebuilt. Finally got around to do some wiring troubleshooting today, now I'm no wiring expert, but all the results just didn't add up. Wasn't getting voltage to the plugs, the secondary winding was open (unless I was reading it wrong) and it seemed like something was shorted to ground but I couldn't find any exposed wires that would short out. Also, since my battery was dead for so long I purchased a new one. I grounded the plugs, kicked it just to see no spark, but when I flipped off my switch it sparked, did it every time. I found that really odd because I've never heard of that nor seen that before. Is that normal?
Now, to my question. My bike has a stock ignition and I had it built when I was overseas. It has a TCbros 6pin harness on it (partnum. 108-0002), and I was going to purchase the 'Ultimate Pamco Electronic Ignition with E-Advancer/Ignition Coil Kit' from Mikesxs (partnum. 14-0907), now can I run that ignition with that harness or no? The reason I am going with the cam-driven is because I plan on swapping to a PMA in the near future, but funds are somewhat short at the moment. Give me some insight here fellas, if my logic is fucked please tell me, or if my choice in PAMCO isn't the best for my future plan then recommend me a different one. XS650 gurus please help.
Now, to my question. My bike has a stock ignition and I had it built when I was overseas. It has a TCbros 6pin harness on it (partnum. 108-0002), and I was going to purchase the 'Ultimate Pamco Electronic Ignition with E-Advancer/Ignition Coil Kit' from Mikesxs (partnum. 14-0907), now can I run that ignition with that harness or no? The reason I am going with the cam-driven is because I plan on swapping to a PMA in the near future, but funds are somewhat short at the moment. Give me some insight here fellas, if my logic is fucked please tell me, or if my choice in PAMCO isn't the best for my future plan then recommend me a different one. XS650 gurus please help.