wallywheels
"savage"
Just as it says looking to monitor my oil pressure and was wondering if a fuel pressure gauge would work for oil? The one I am looking at is 0-100 psi
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Can a fuel gauge be used for oil?
- Thread starter wallywheels
- Start date
These bikes have very low oil pressure. A 0 to 30 psi gauge would be a better choice.
wallywheels
"savage"
Paulrxs650
XS650 Enthusiast
Where are you planning on attaching the guage / connecting to?
wallywheels
"savage"
I am running a turbo so I will be tapping into the front of the clutch cover where the oil feed is.
wallywheels
"savage"
sure will I am going for keeping it under 1000.00 for everything so far..
290.00 turbo
47.00 flange set
20.00 gasket
10.00 banjo bolt
100.00 inter cooler
29.00 gauge boost
50.00 gauges fuel and oil pressure
100.00 boost regulated fuel pressure regulator
40.00 30GPH in line fuel pump
140.00 Builder kit for exhaust piping to turbo
20.00 1.5 mm carb needle valve
I am running a single carb setup I already had in place VM mikuni 36
total so far 896 And I have at least 100.00 in copper piping and lines for all my gauges so well see
290.00 turbo
47.00 flange set
20.00 gasket
10.00 banjo bolt
100.00 inter cooler
29.00 gauge boost
50.00 gauges fuel and oil pressure
100.00 boost regulated fuel pressure regulator
40.00 30GPH in line fuel pump
140.00 Builder kit for exhaust piping to turbo
20.00 1.5 mm carb needle valve
I am running a single carb setup I already had in place VM mikuni 36
total so far 896 And I have at least 100.00 in copper piping and lines for all my gauges so well see
