nwhitehorne
XS650 Enthusiast
anyone know of a cheep place to get (or have one for sale) an engine jig so when i chop the frame it stays square well i am getting the hard tail attached?
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
engine jig
- Thread starter nwhitehorne
- Start date
-
- Tags
- frame
3Deuces
XS650 Addict
Just make one. I used some old scrap galvanized 1"tubing that I found in my garage. Measure the widths of the mounting points on the engine, cut to length and bolt into the frame. Then just connect the points in a somewhat triangular fashion.
Paulrxs650
XS650 Enthusiast
If you have the engine leave it in the frame til choped and at least tacked up - thats what I did with mine and no wonky problems 
nwhitehorne
XS650 Enthusiast
hey guys thanks for the good info.
