Jaymichael
XS650 Addict
Hey all. So I was setting up my clutch adjustment today and realized there was too much space between the actuator and the clutch rod. Took a look at the diagram and doh! Pretty sure I have forgotten the ball bearing that goes between the clutch rod and the push crown on the clutch pack side. I swapped out my multi piece rod for a 1 piece and I guess I wasn't aware I still needed that ball bearing.
Now, my question... Can I pull the 1 piece push rod out the left side and simply add the missing ball bearing and then push it across with the rod? Or do I need to full my ride side cover and install from the clutch pack side?
Any help appreciated!
Now, my question... Can I pull the 1 piece push rod out the left side and simply add the missing ball bearing and then push it across with the rod? Or do I need to full my ride side cover and install from the clutch pack side?
Any help appreciated!