I have a stateside 79 2f, I have replace the harness and the handlebar controls with new ones from Mikes XS, but the front and rear lights don't work,
The bike runs,
I have a new pma and getting 14.5 volts at the battery.
Horn, signals, stop light, and neutral light work fine.
There is power at the light fuse, in fact all the fuses are ok.
I don't have a flasher cancelling unit but have one on order.
Naturally as I now have a pma a couple of things are different I have used the switched live for the old regulator on the new Reg/Rectifier.
The yellow that goes to the safety relay I have tried sending a current down but nothing changed.
All ground wires have very goog contacts.
I am keeping the bike pretty much as it came out of the factory except for 3 things which are the pma, exhaust and a new Boyer Bransden ignition all of which are installed and working fine.
Any help will be much appreciated.
The bike runs,
I have a new pma and getting 14.5 volts at the battery.
Horn, signals, stop light, and neutral light work fine.
There is power at the light fuse, in fact all the fuses are ok.
I don't have a flasher cancelling unit but have one on order.
Naturally as I now have a pma a couple of things are different I have used the switched live for the old regulator on the new Reg/Rectifier.
The yellow that goes to the safety relay I have tried sending a current down but nothing changed.
All ground wires have very goog contacts.
I am keeping the bike pretty much as it came out of the factory except for 3 things which are the pma, exhaust and a new Boyer Bransden ignition all of which are installed and working fine.
Any help will be much appreciated.