Slaserj
XS650 Member
Hey everyone! I've read through all the posts about the pamco install, and something still isn't lining up. Almost done installing my pamco, and a little worried about the bushings. There are 3 supplies, but room for 4 on the shaft. Two were installed by me on the right (behind advancer), and one by me on the left (behind Pamco). Now, it appears that there is room for one more on the left. When I tighten the nut on the magnet disk side, it tightens the aluminum magnet disk against the steel of the camshaft (first ring seen inside the hole). I'm assuming this is incorrect, as it completely disables the advance. Is there supposed to be a recess like this? Am I missing a factory part? Note the brass bushing deep inside.