Rear hub advice - sportster etc

[littleslip]

Sweet work

What reamaster cylinder / caliper is the bike from?

You running a radian swingarm?

 

[hoffman900]

Sweet work

What reamaster cylinder / caliper is the bike from?

You running a radian swingarm?

A late '90s RM250.

And yep, that's a Radian swing arm that's been shortened (per dimensions in the other thread). It has a 17mm axle. I'm not sure on the exact measurements of a XS650 set-up. You may need to move the shock mounts to get the proper angle.

These are the bearings for to make that hub work on a 17mm axle:
2x 17x47x14mm bearings (part #63032RS)
1x 17x42x12mm bearing (Honda #91003-KRM-841)

The Honda part number is the only tricky one to track down. It's an internal transmission bearing from a XR650. You can get them, just expect to pay a little more for it.

 

[nvr2late]

Here ya' go. I also have a larger caliper bracket if I ever wanted to put a larger diameter rotor on it (would probably foul on the shock, however... the caliper might need to be shaved a bit if I did that).

Thanks for the photo's

 

[Okie]

I agree about the omars kit, but I just fancied going this way for a more custom look than buying a kit. It gives me a project to plod along with!!

Ill take a look at your build post.
Richard got back to me with some great info as to what's needed

So what brake rotor will you be using with this setup? Are you using the stock Harley rotor?