Coastside, could you give a little more detail about the license plate bracket and light. I'm looking to fab up something similiar. I'd like to know thicknesses of the steel you used and the "what" and "where" about the light you mounted to it. I appreciate it.
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Rephasing project for a 77 bobber
- Thread starter CoastsideXS650
- Start date
-
- Tags
- engine
CoastsideXS650
Princeton Motor Works
Coastside, could you give a little more detail about the license plate bracket and light. I'm looking to fab up something similiar. I'd like to know thicknesses of the steel you used and the "what" and "where" about the light you mounted to it. I appreciate it.
The light is a cheapo light from the local auto store. The steel is 16ga reinforced with some flat bar stock. Maybe 1/4" thick to give it a little strength. I would have made it from 18ga but didn't have any lying around.
CoastsideXS650
Princeton Motor Works
So I realized that I never finished off this build thread after all this time. I have put pictures up in other threads but this is just to tie things all up.
There have been a few changes over time. Mostly the addition of a tall sissy bar but overall these show the finished product.
There have been a few changes over time. Mostly the addition of a tall sissy bar but overall these show the finished product.
