Hey all, Heres some updates.
Electrical Tray: Small and tight, enough to hold a blade fuse panel. Ill be bolting the reg/rec to the bottom, and running hughs pma, petes pamco, and a capacitor.
Note: I forgot to take pictures after I bent up the last piece at the back of the tray, as well as the front mounts. Whoops! Ill get some once its welded up and painted.
Seat pan. The front piece is 16ish gauge sheet steel, and is there to cover up the tank mounts, and still allow easy, instant removal of the seat.
The rear of the pan is shaped underneath to allow the fender to fit a little tighter, as well as around the middle is shaped to fit around the frame brace. This all together keeps the seat as flat as possible on the frame for a flush fit.
Rear fender mockup. Chopped up front fender, will just have a small steel mount, most likely bolted to the rear of the frame.
Managed to get the frame stripped down, and painted with the first two coats.
Right hand side engine cover. Polished, masked, and painted black on the front.
Thats all for today folks. Let me know what you think so far!