This is my XS1B front fender. Every time I looked at it, I thought that it was very slightly bent and would require a little straightening.
I finally removed and disassembled the fender so that I could clean and restore it. It turns out the end curves are NOT SYMMETRICAL.
This distance, measured from the edge of the strut hole to the edge of the curve as shown, is 60mm on one side and 56mm on the other side. It is quite noticeable. My fender is a actually perfectly straight, but it looks bent because the ends are not symmetrical.
This is the back of the front fender. On the front edge, the situation is even worse. The strut-hole to fender edge measurements on the front are 54mm and 48mm.
Has anyone else observed this on their XS1 or XS1B front fender?