Okay, I am getting very annoyed with the problems I am having with this bike . The bike is an 83' Heritage. At first, I found that I had a bad Stator. I replaced the stator with an older model, and tapped out the position for the pick-up. I replaced the brush assembly from my 83 stator to the older stator due to the constantly grounding. I was getting some charging and then it stopped again. I tested the rotor and it tested good. I tested the reg/rect. and was not getting the spec readings. I built the chryler reg/Rect. and mounted it and then I checked the rotor and was getting really low readings. I replaced the rotor with a new one from TC Bros. The rotor tests good. I measured the brushes and they are between 11 and 12 cm.
I followed Curly's guide and:
1: completed
2: Slap test --Failed
3: Jumped the ground on the reg/rect. no change in voltage
4: I have checked the brown wire and have gotten voltage readings similiar to the battery, however, i put the red probe on the screw that holds the brush to the stator and I do not get any voltage readings????
5: I am getting 5.5 ohms on the slip rings
6: The testing at the stator connector, I am getting no readings. I have the meter set to AC (200) and i am placing both probes on different combinations of the white wires and I am not getting any readings. Everything says 0.00
7: I am getting right about the spec readings
Please help i really want to ride and not have to push the bike home when it sucks the power dry.
I followed Curly's guide and:
1: completed
2: Slap test --Failed
3: Jumped the ground on the reg/rect. no change in voltage
4: I have checked the brown wire and have gotten voltage readings similiar to the battery, however, i put the red probe on the screw that holds the brush to the stator and I do not get any voltage readings????
5: I am getting 5.5 ohms on the slip rings
6: The testing at the stator connector, I am getting no readings. I have the meter set to AC (200) and i am placing both probes on different combinations of the white wires and I am not getting any readings. Everything says 0.00
7: I am getting right about the spec readings
Please help i really want to ride and not have to push the bike home when it sucks the power dry.