TeknoRob
XS650 Enthusiast
Hey guys
I was wondering if any of you could pass me some advice.
I had a dabble in mig welding the other week and would like to do more welding. The things I'm looking at doing are like bungs for fender struts, electronics box... And future project bikes as well.
It'd definitely be a handy skill for outside the motorcycling also.
I will be practicing a lot on sheet metal but whatever mig I buy I want to eventually use on my bikes too.
What can you guys tell me too look for in a mig welder?
So far from reading I'm convinced gas would be suitable, and a continuous feed would make life easier, but what about amperage and so on?
Thanks
I was wondering if any of you could pass me some advice.
I had a dabble in mig welding the other week and would like to do more welding. The things I'm looking at doing are like bungs for fender struts, electronics box... And future project bikes as well.
It'd definitely be a handy skill for outside the motorcycling also.
I will be practicing a lot on sheet metal but whatever mig I buy I want to eventually use on my bikes too.
What can you guys tell me too look for in a mig welder?
So far from reading I'm convinced gas would be suitable, and a continuous feed would make life easier, but what about amperage and so on?
Thanks