Hi;
I've recently bought an 1971 XS1B, but the rear has been cut to fit another type of seat;
I would like to rebuilt it to factory look, can some one help me getting some sizes for the rear part of the frame;
Note: if someone has cut it from a bike and would like to sell it, i would be interested;
I Believe the diameter is 19mm (0.74 inch) , is this correct
A: from top inside to the point where it start's to curve
B: From the curve to the welding point
C: on the curving point the distance from one side to the other (from inside the frame)
D: Distance between the two welding point (i think i have this one )
E: The distance from the top (bottom of the tube) to an "imaginary line" along the frame
F: the length between the most outer part of the tube to the welding point
G: if possible the angle of the curve
Thanks
I've recently bought an 1971 XS1B, but the rear has been cut to fit another type of seat;
I would like to rebuilt it to factory look, can some one help me getting some sizes for the rear part of the frame;
Note: if someone has cut it from a bike and would like to sell it, i would be interested;
I Believe the diameter is 19mm (0.74 inch) , is this correct
A: from top inside to the point where it start's to curve
B: From the curve to the welding point
C: on the curving point the distance from one side to the other (from inside the frame)
D: Distance between the two welding point (i think i have this one )
E: The distance from the top (bottom of the tube) to an "imaginary line" along the frame
F: the length between the most outer part of the tube to the welding point
G: if possible the angle of the curve
Thanks