71XS1B Carbs NeedleJet03 The nozzle protrudes above the venturi floor only about 2.5mm (0.100"). Stop tapping the punch when it meets the venturi fl
71XS1B Carbs Screws02 Drill a 1/16" (0.062", 1.5mm) hole, centered in the broken screw.
71XS1B Carbs Screws01 The inevitable broken throttle plate screw. This must be removed, without damaging the throttle shaft or butterfly valve.
71XS1B Carbs NeedleJet04 After being unseated from its recess, the nozzle can be removed.
71XS1B Carbs NeedleJet03 The nozzle protrudes above the venturi floor only about 2.5mm (0.100"). Stop tapping the punch when it meets the venturi fl
71XS1B Carbs NeedleJet02 Insert the punch through the nozzle from the top. While holding carburetor upright, gently tap the punch downward.
71XS1B Carbs NeedleJet01 To remove stubborn/stuck nozzle, use a brass, aluminum or plastic punch with a 3mm or 1/8" shaft.
71XS1B Carbs EndCaps To remove endcaps for shaft seal removal, use curved-jaw mini vicegrips. Clamp lightly, but firmly, on only the outer half of t
TwoManyXS1Bs

71XS1B Carbs NeedleJet03 The nozzle protrudes above the venturi floor only about 2.5mm (0.100"). Stop tapping the punch when it meets the venturi fl

There are no comments to display.

Media information

Album
1971 XS1B BS38 carburetor rebuild
Added by
TwoManyXS1Bs
Date added
View count
752
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top