IMG 27- Using a pair of Channellocks, the springs really have to be compressed to fit properly. The flat sides of the springs need to fully pocket int
IMG 24- Picture of Steel plate on top of Primary Drive Gear and Clutch Housing, looking from the back.
IMG 25- All the new cush springs are the same size, however. . . .all the openings are not! 3 openings in this steel plate are smaller and these are t
IMG 26- Wrong way to install springs, must be every other smaller opening.
IMG 27- Using a pair of Channellocks, the springs really have to be compressed to fit properly. The flat sides of the springs need to fully pocket int
IMG 28- Don't install springs next to each other, like this photo. Just install 3 springs into the smaller spaces, every other opening.
IMG 29- Make sure spring is all the way in the pocket, with flat side of spring compressed against both sides.
IMG 30- Carefully pocket springs on their flat side surfaces.
YAM277

IMG 27- Using a pair of Channellocks, the springs really have to be compressed to fit properly. The flat sides of the springs need to fully pocket int

There are no comments to display.

Media information

Album
Cush Springs / Dampening Springs Guide for Replacement
Added by
YAM277
Date added
View count
667
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top