IMG 59- Thrust washer goes over 1 mm washer. Notice how thrust bearing is flush with basket. Workshop Manual says to add heavy grease to hold flat thr
IMG 56- Close up pic.
IMG 57- No washers shown in this picture, but you can see spacer showing around shaft, in the center.
IMG 58- 1st washer in this set, starts with the 1mm washer first, notice position on shaft.
IMG 59- Thrust washer goes over 1 mm washer. Notice how thrust bearing is flush with basket. Workshop Manual says to add heavy grease to hold flat thr
IMG 60- 2mm washer goes over thrust washer.
IMG 60A- Basket showing new Allen bolts installed from Cush Spring Kit. M8 X 1.25mm. Bolt length is 20mm.
IMG 61- Pushrod close up pic.
YAM277

IMG 59- Thrust washer goes over 1 mm washer. Notice how thrust bearing is flush with basket. Workshop Manual says to add heavy grease to hold flat thr

There are no comments to display.

Media information

Album
Cush Springs / Dampening Springs Guide for Replacement
Added by
YAM277
Date added
View count
453
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top