There was a screw holding this in, but I'm not sure how to get this piece out now that I removed the screw. Theres some metal bouncing around behind t
Oil temp gauge dipstick made by a guy in Austin.
The outside of the case where this bearing is looks like a freeze plug... so does the whole thing just press out?
Put an impact on that nut and it wouldn't budge.
There was a screw holding this in, but I'm not sure how to get this piece out now that I removed the screw. Theres some metal bouncing around behind t
I'm guessing this is just a casting flaw?
So this area looks jacked up next to where the kick shaft plugs in.
Jumpstreet Customs foot controls
Ranger

There was a screw holding this in, but I'm not sure how to get this piece out now that I removed the screw. Theres some metal bouncing around behind t

There are no comments to display.

Media information

Album
Ranger's 2016 chopoff build photos
Added by
Ranger
Date added
View count
615
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top