Recent content by Big Todd

uni filter with K and N oil on them. what is wrong with the idea ?

TX650 Cafe Racer. Mikes XS barrel Kit , Valve work. 79 rebuilt front end

cut rear fender

that sounds like a good plan. I will give it a Go Sunday

Fresh motor going into TX 650, cant get the motor mounts lined up, Were should I start on 1st mount ? I started at the top mount but that wont work

Thank you for the quick get back, The extra drawing is a nice tidbit of Info too. I Cut down the tail of a dull drill bit and used it as a lock pin for points cam

TX650 timing trouble, Just a Question about the cam for the points, Mine has no key ? It keeps blowing the carb off the right boot. I see a hole in the shaft and a slot in the the cam that opens the points but no lock pin so the cam can sit anywhere it pleases on the camshaft end, dont seem right ?

Last years project doing a much needed Beer run