kwhy3000

Hmm I always thought it was the gasket surface… this diagram from the manual makes it hard to tell.

I appreciate the post but I’ve been flooding with fuel, with carb cleaner, air. It’s just weird it doesn’t overflow when on the bike...

Carbs are brand new. When bowls are off, float needles turn on/off like they should. Taking measurements off gasket surface. Floats seem...

Vm34’s. Getting fuel pooling in intakes. Set float tangs 22-24mm. Clean out float valve. Float/float valve test on bench shows fuel...

Thank you for clearing this up. I will continue with the 22-24mm tang measurement.

Absolutely. They say the tang measurement from gasket surface should be 22-24mm. Obviously that is not correct in my case if the fuel...

The tangs measure 23mm from gasket surface but when I measure with the clear tube method with the carbs put together I am about 8mm...