Recent content by payaso13

  1. payaso13

    Sold / Found / Inactive - Left side engine case cover (78)

    Thanks for the offer but I figured out what was wrong with the one I had🙄
  2. payaso13

    Sold / Found / Inactive - Left side engine case cover (78)

    Ok nice..have a pic? And price?
  3. payaso13

    Sold / Found / Inactive - Left side engine case cover (78)

    I don't think the early covers are the same as later years though
  4. payaso13

    Sold / Found / Inactive - Left side engine case cover (78)

    Looking for left side engine cover for my 78 Thanks
  5. payaso13

    Carb needle

    Sounds good...I checked ebay and found 2 nos xs650 needles..didn't think of looking there
  6. payaso13

    Carb needle

    Yes my fault..I went on niche and searched 502 but didn't show. I'll take a look again..also how did that xs400 needle work out?
  7. payaso13

    Carb needle

    I have 1978 bs38 Uni pod Open taper mufflers Just cleaning my carbs out since I haven't riden in a while I currently have 140 main 30 pilot Z-2 needle Stock needle as far as I can tell..but looking on niche cycle for a same needle size z-2 but can't find it. I seen another post with 5twins...
  8. payaso13

    Sold / Found / Inactive - 1975 and 1978 standard lot for Sale in NC

    Yes I think you're right on all standards being same fit...color and decals don't matter to me...I think as long as there not special side covers they'll fit..I'll keep on eye on this post. Thank you sir
  9. payaso13

    Sold / Found / Inactive - 1975 and 1978 standard lot for Sale in NC

    Do you have a pair of 78 standard side covers available?
  10. payaso13

    Sold / Found / Inactive - Side Covers

    Ok thank you for reply..I'm looking for a pair. But might need to get 1 at a time.. haha
  11. payaso13

    Sold / Found / Inactive - Side Covers

    Any black standards left?
  12. payaso13

    On/off ignition wiring

    I do have a heavier duty switch on off start...but i dont want to use it to start bike. Id like to use start button on rt bar switch. Can it still be wired and just not use momentary start? Or what relay should i use for current on off switch? Just did some looking around...30 amp realy sound good?
  13. payaso13

    On/off ignition wiring

    I do have stock kill switch on handlebars..and stock starter relay..so how about from starter relay through 20 amp fuse to ignition (red wire) then black wire to fuse box to power everything else? I only say from the starter relay because i have a 14ga wire i believe goes to ignition switch that...
  14. payaso13

    On/off ignition wiring

    79 hardtail Pamco/pma Stock handlebar controls Stock starter relay Trying to figure out how to wire this on/off switch. Red and black is on position, so does that mean red and black combined to my fuse box to power everything else? What do i do withthe off position wires?
  15. payaso13

    Wiring question

    Thank you sir for these.
Back
Top