PeteP275

Hi all, I see that some of the rubber bushes and dampers etc are available, any idea on where I can find those that aren't listed on the...

Hi Mez, thanks for getting back to me, I have had some 3d printed locally to me. Cheers. Pete

Sorry to be apain do you have a shot of the other side please. Ta Pete

Do you have a picture of the inside of the clutch housing, I cannot see the end of the bronze bushing as it is covered by what looks...

I have just checked the mainshaft endplay, it is over 0.7mm = @0.027.5 inch

I will try and get some pix for you and the clutch basket is inmodified.

Hi, the reason the whole engine was stripped was the clutch shaved the crankcase and metal swarf went around the engine. When stripped...

Hi just to confirm my bike is an XS1b, 1971, the friction and clutch plates are the correct number and thickness for that year/model of...

Already confused, I knew it was in 2, not 3. I live in a permenant state of bewilderment!!

Hi all I have read some posts about the basket spin test were you were able to spin the basket by hand after you had torqued up the hub...

Hi all I take it when you say the basket spin test you were able to spin the basket by hand after you had torqued up the hub nut. I...

Hi there, thanks for getting back to me, I have 1x1mm and 1x2mm washers behind the clutch basket as per the diagram. It also appears...

Hi 5twins, I have got round to rebuilding the clutch on my xs1b, when I use the washers as shown above and then torque the drive shaft...