rsor

Did anyone have info for this fellows question?

I guess that was the thought I was not wanting to do is run a tap inside of the threaded hole. Happy that I did not have to do that.

Maybe.........it's a strange world!

Pushed a very thin screwdriver into the hole, it went in at least as far as the length of that bolt. Tried it one mor etime and it went...

The bolt is not shouldered, it just seems too long. Though I am usually very careful about what went where.

Definitely longer than 12mm. Not sure how it got in there if that is the case.

Why won't this fastener go in all the way?

Winter wonderland? Our snow has almost disappeared as of March 26, and this fell over the last two days!

They have gone back to Government regulated road test here in that land of the Canuck precipitation as too many people were buying a...

All seals being replaced when I put the motor back together.

Found some sort of square cut o rings at a local "have all" supplier. They have a bit of a groove in them, but fill the void where the...

Thanks, I will check the info out.

May well be the only solution I suppose.

https://www.kijiji.ca/v-street-cruisers-choppers/edmonton/1979-yamaha-xs650/1710992663

Is there a solution to these cracked and worn out friction gaskets in the starter case?