Search results

That's what I thought, thanks!

So this may be a stupid question BUT is there a need for a kill switch and an ignition switch for the Boyer to work properly?.... its like a switch on the switch isn't it? Or do some countries have regulations for a handle bar kill switch? Please clear this up for me. Lester

Thanks XS Leo, I wasn't arear it was mikes that had them. I could have sworn it was an e-bay vendor with very good reviews. None the less I'll check Mike out about this. Lester

Hey guys, I read some where on here that there is a supplier that you can order custom length brake line with swiveling fittings. I can't find this info and I anm finishing up a project and need to make the order asap. Can anyone please help me with a tip to a reputable supplier for the...

these guys are good Calles Chopperdelar Sweden AB

PM me if you still have them Leser

I think so but it not a highway touring bike.

It will be quite a bit lower I ride my wifes bobber that has a modified monster kit every now and then and its not a problem really... but lower for sure... knew are just a bit up.... I'm 6'2" 225.

Found it !

Can any body post installation instructions for Omars Kit. lost mine Lester

Hey Guys, My welder buddy went way out of his way on his last day off to weld up my Caliper Bracket lug... I'm over the moon... but I wish he had welded up some more on the back side of the lug so I could have given it some more shape.... Its a freebee on a Sunday so I smiled and thanked him...

Hey guys... Yea the configuration of my hard tail and axle plates will not allow this with out swapping caliper, bracket ect ... which I don't really want to do. Ill keep it in mind for a future project though! Seen I before on big twins too ,sweet set up really. Lester

Hmmm... I didn't manage to get this configuration to work on my hard tail when looking at the possibilities. May have something to do with yours being a loop. I'll have to check this again now....LOL Nice bike by the way Lester

Hey guys, Here are a couple pictures of the weld jig I've made up for the relocation of the brake stay lungs on the caliper hang-off bracket. I am having a welder friend help me out with the Alu. welding, he is a journeyman so I woun't get it back for a couple weeks. I have plenty else to do...

I've thought about the bleeding bit too..... May just unbolt it bleed it and re-bolt.... no big deal as this is not to be done so often. Good one! thanks Lester Norway

Hey guys, I've looked at having the caliper mounted between the two tube but this would totally mess up chain tensioning ect... no go. This is the reason why the caliper bracket is mounted to the wheel axle in the first place. I chopped of the lugs and prepared them for welding. I am working...

Thanks for the answers, Making a wrap around rod is not an option for me... my goal is to building a simple clean bike. I'm sure it would work either way. I thought about moving and re-welding the lugs but I have had disappointing results with Japanese cast Aluminum before. I'll give this...

Hey Guys, This has probably been covered before but I am not having luck finding the info I am after. I am running a David Bird hard tail with a front 19" mag in the back with original rear disk. I would like to hang the caliper straight down as shown on the picture, this will leave the brake...

Great build, really like your remote brake setup Keep the updates coming in Lester

Hello Al, Thanks for asking, its an honor. Feel free to use any pictures and info you like in this thread. Best of luck with your site Cheers Lester