Search results

When Im cruising and accelerating it sounds fine, but when I let off the throttle and coast the tranny makes a pretty loud clanging and clashing noise, especially at low speeds on a bumpy road, it will clang and kind of jerk forward and back. When I had the motor out i did notice that with the...

If I leave it off will it cause engine problems?

is there a cruise control unit that will fit my stock throttle and 7/8" bars?

would a stock bs38 carb (maybe after some rejetting) be enough carb to supply both cylinders?

one that fits a '78

I got a set of 6 over forks "forking by frank". The fender bosses have been smoothed but caliper mounts are still there. They are 36" from axle center line to top of upper tube (not counting caps). I need some stock forks. Ran them all last summer and they ride great. I emptied the oil...

Hey I got some 4 over forks done by frank. They are 35.5'' long. How do I return these to stock, 29.75" i think? Underneath the springs are some 6'' pieces of pcv pipe, I assume was put in there by Frank. But when I removed the pipe and reassembled the forks but it was like they were bottomed...

Is there any rake built into the stock trees or are they parallel with the neck?

when im putting on the timing chain i line up the mark on the stator to put in on TDC, but which cylinder should be on the compression stroke when the mark on the cam is up. I assume it will be the left one but i just wanted to be sure.

The plastic on my cam chain guide fell off and i was finding shavings in my oil filter, so i tore my engine down to replace it, i went ahead and took the cylinders off to replace the gaskets. While I have it apart should put rings on the pistons or are the old ones alright to reuse. Its got...

Hey i got a '78 SE with 38mm mikunis. Well, one of my carbs vibrated out of its holder and leaked fuel, so next thing i know in comin down my road on fire. Well i got it to the house and hosed it down. Then i replaced the charred wires and fuel lines, new carb holders and built a support bracket...

It idles good at like 8 or 900 but when i rev it up it stays high. After about 10 -15 seconds it will come back down.

Yeah just got the bike out for its first real run on the road. and I noticed the front wheel wobbles side to side like its not true. Its a stock front end. Could the wheel bearings be bad? I re-spoked the wheel and had it trued, but maybe it's not right.

I have A Solid State Reg/Rec combo from Mikes. I think it might be bad, is there a way to test it?

But i got a charging problem. I posted it earlier about wiring the brushes.

Hey, Im running a Mikes Rec/Reg and a Pamco ignition. Ive seen some diagrams that show my green brush wire running to my orange regulator wire and grounding the black brush wire. And other digrams put green to orange like before, but take the black brush wire and run it to switched power (along...