Search results

  1. prue1

    Are there any particular problems with the 1976 version of the XS 650 that one should know before purchase? Thanks.

    Are there any particular problems with the 1976 version of the XS 650 that a perspective purchaser should know about prior to purchase? Thanks.
  2. prue1

    Horn

    Can anyone recommend a good horn for a 72? one that will fit under the tank like stock. My original and aftermarket horns are basically useless. Thanks.
  3. prue1

    Rear Brake Adjustment

    OK, my gray matter is disappearing rapidly that is why I need help! When I adjust my rear brake on my 72 XS2 to the one Inch spec, my rear brake will engage when hitting a bump. This happens until the brakes get warm. In order to correct this problem, I need to adjust the brake pedal to engage...
  4. prue1

    Oil leak 72, XS2

    I have a very small oil leak which appears to be coming from the side of the left cylinder just under the head gasket. After a 30mi ride all that appears is a sheen of oil on the fins. I haven't even seen a noticeable effect on the oil dip stick but there's no doubt that the oil is there ( the...
  5. prue1

    50 year anniversary

    50 years ago today, my friend and I began a adventure of a lifetime. At the age of 18, we began our trip across North America. Me riding my new 1971 XS1 and my buddy on his 68 sportster. We travelled from Union Lake MI, north on I-75, west on the Trans Canadian Hwy, South on the Pacific Coast...
  6. prue1

    air/exhaust leak

    Two questions: 1. It appears I have an air leak in the throttle shaft seals on my 1972 XS650 (BS38 carbs). When spraying starting fluid on the shafts, my rpm's increase. I can maintain a decent idle, but the popping and hick ups seem to be getting worse over time. I've kind of lived with it for...
  7. prue1

    Voltage at Battery

    Hi Guys, my 72 XS2 continues to have battery (premature failure) issues. I always use a battery tender between rides. My last battery (AGM Motoblat) lasted two months. I get a maximum of 14.3 - 14.5 of volts at the battery at around 5000rpm with the lights off. With the lights on, the most...
  8. prue1

    Float bowl screws/leaky carbs

    Hello everyone! My 72XS2 has two leaky original carbs. The float bowls are secured to the carb bodies by 4 screws per carb. Each carb has one screw that has stripped threads in the aluminum receiving carb body. This has caused a imperfect seal and therefore fuel leaking from the lower carb or...
  9. prue1

    New Battery Recommendation

    I seem to go through batteries too soon (about every year), even when kept on a tender. Does anyone have a recommendation for a new AGM battery to fit a stock 1972 XS650? Thanks.
  10. prue1

    Wanted - Bearing Spacer

    Just to clarify: It's #7 in the exploded view of the front wheel in the manual, It MUST be from a 72. It has a small hole in the middle of the spacer. Thanks.
  11. prue1

    Wanted - Bearing Spacer

    Wanted in usable condition: Bearing spacer for front wheel/hub, 1972 XSB.
  12. prue1

    Front wheel 72 XS2

    I'll try this again, If I tighten my front axle I get a very noticeable clicking noise and my speedo hub wants to move with the wheel. If I loosen the axle the noise goes away for the most part, but my speedo hub still wants to move with the hub, although not as quickly. I believe I have all the...
  13. prue1

    Front wheel

    I noticed that my speedometer drive gearbox housing was not positioned correctly (the arrow was not pointing up), So I loosened the front axle (it was not real tight) and re-positioned the speedo drive. Tightened the front axle and away I went. Did not get far and heard front end noise. Back to...
  14. prue1

    neutral light

    After many years of working, my neural light is always on regardless of the gear I'm in. Any thoughts? As always, thanks.
  15. prue1

    Battery Problem

    My problem: my batteries keep going bad. I have an early ascension cycle works/XS charging system (stator and rectifier) that is 4-5 years old, my last battery, a Motobatt AGM lasted around 3 months.My electrical meter says I have 12.5 volts, but when I apply a load, my meter indicates my...
  16. prue1

    Battery Problem

    Hi, looking for some guidance. I have a 72 with a Pamco Hall effect ignition and stator assembly. My problem is that I keep going through batteries. I estimate that I can get between 2000 miles/12 months out of a battery. I am using a AGM/160cca battery. This is my third battery in about 8000...
  17. prue1

    1980 ignition problems

    My friend recently acquired a 1980 XS 650 special. It is my understanding that this was the first year for pointless/electronic ignition. It has no spark, any advice on where I should look first? Thanks.
  18. prue1

    Electrical/Charging problem

    I have a 72 XS650 with an aftermarket Ascension Cycle Works charging system and a Pamco ignition. On occasion, when I use the electric start, my neutral light dims and the starter will not turn over the engine. When I check the voltage at the battery it reads under 12 volts. I try again, the...
  19. prue1

    Battery

    I am in need of a new AGM 160 cca battery for my 72 XS650B. I am currently using a battery from MikesXS, but it is aging. I have used the Motobatt brand, but am not a fan of the connection posts. Can someone recommend a battery and where I can get one. Thanks.
  20. prue1

    rear shocks

    Hi, looking to upgrade from my stock 72 XS650 rear shocks, any suggestions? Thanks.
Back
Top