Search results

  1. yghp

    camshaft doesn't turn

    1979 650 special, the bike just died. It is getting power to the points but the camshaft is not turning when I crank the motor. I can grab the nut on the end and turn it by hand. Does this mean the cam chain is broken, and how hard is it to change?
  2. yghp

    It just quite, no spark

    I have a 79 650 special. It just died, It smelled like something was hot or burnt but I couldn't pin point what. After pushing it 1/4 mile home the smell wasn't as strong. It has no spark on either side. The fuses are good, the battery is charged, no pinched wires. Does anybody have any ideas. I...
  3. yghp

    Wanted - bs 38

    I need a set of carbs for a 1979 yamaha 650 special.
  4. yghp

    Oil under points cover

    Should there be oil under the points cover, on a 79 650 special. It is not a lot of oil it looks like weeping and settled in the bottom of the cover.
  5. yghp

    Can't adjust idle

    The bike idles at 4000 rpm, when i back off the idle screw nothing happens because the screw is not touching the adjusting rod. I have a 1979 650 special. It has a 2 into 1 exhaust. I cleaned the carbs, replaced the needles and seats. I increased the main and pilot jets one size. I did not...
  6. yghp

    79 special valve clearance

    I can't seem to find definite specs for valve clearance. Is the intake .0024 or .004? Exhaust is .006. Thanks for the help. Born on date is 12/78
  7. yghp

    Spanner wrench

    What is the correct wrench to adjust shocks? I have ordered two different wrenches neither one work:banghead: It might be operator error:( I have used a pipe wrench, but that is ugly.
  8. yghp

    2 into 1 blue pipes

    The previous owner of my 79 yamaha 650 special put on 2 into 1 pipes. Now that I got the pipes to seal, they are turning blue and it does a rumble backfire when I decelerate. Plugs are light colored, should I change the jets? One size up? Thanks for any help.:shrug:
  9. yghp

    painting pipes

    Has anyone painted their exhaust pipes? My 2 into 1 pipes are starting to rust in between the pipes. Should i sandblast a paint. How hot do pipes get.
  10. yghp

    Remove clutch basket

    Is it a obvious procedure? Remove screws, remove nut, slide clutch off shaft? Or is it pressed on, or a reverse thread. I have a manual ordered but it has not come yet. I am trying to get to the starter spring clip. Thanks for any help/ advice.
Back
Top